| Skip Navigation Links | |
| Exit Print View | |
|
Oracle Solaris Cluster Data Service for Samba Guide |
1. Installing and Configuring HA for Samba
Planning the HA for Samba Installation and Configuration
Restriction for the supported configurations of Samba
Restriction for the Location of Samba files
Restriction for the Samba smb.conf files
Restriction for multiple Samba instances that require winbind
Determine which Solaris Zone Samba will run use
Dependencies Between HA for Samba Components
Required parameters for the Samba smb.conf file
Installing and Configuring Samba
How to Install and Configure Samba
How to Check Samba is installed with Solaris 9 or 10
How to Install and Configure Samba downloaded from http://www.samba.org
How to Prepare Samba for HA for Samba
Verifying the Installation and Configuration of Samba
How to Verify the Installation and Configuration of Samba
Installing the HA for Samba Packages
How to Install the HA for Samba Packages
Registering and Configuring HA for Samba
How to Register and Configure HA for Samba
How to Register and Configure HA for Samba in a failover resource group
How to Register and Configure HA for Samba in an HA Container
Verifying the HA for Samba Installation and Configuration
How to Verify the HA for Samba Installation and Configuration
How to Migrate Existing Resources to a New Version of HA for Samba
Understanding the HA for Samba Fault Monitor
Probing Algorithm and Functionality
Operations of the winbind probe
How to turn on debug for HA for Samba
A. Deployment Example: Installing Samba packaged with Solaris 10
B. Deployment Example: Installing Samba from http://www.samba.org
The following table summarizes the tasks for installing and configuring HA for Samba and provides cross-references to detailed instructions for performing these tasks. Perform the tasks in the order that they are listed in the table.
Table 1-1 Tasks for Installing and Configuring HA for Samba
|
|