Skip Navigation Links | |
Exit Print View | |
Oracle Solaris Cluster 3.3 With Sun StorEdge 6120 Array Manual |
Storage Array Cabling Configurations
How to Install a Single-Controller Configuration in a New Cluster
How to Install a Dual-Controller Configuration in a New Cluster
How to Add a Single-Controller Configuration to an Existing Cluster
How to Perform Initial Configuration Tasks on the Storage Array
How to Connect the Storage Array to FC Switches
How to Connect the Node to the FC Switches or the Storage Array
How to Add a Dual-Controller Configuration to an Existing Cluster
How to Perform Initial Configuration Tasks on the Storage Array
How to Connect the Storage Array to FC Switches
How to Connect the Node to the FC Switches or the Storage Array
How to Create a Logical Volume
How to Remove a Logical Volume
How to Upgrade Storage Array Firmware
How to Remove a Single-Controller Configuration
How to Remove a Dual-Controller Configuration
Replacing a Node-to-Switch Component
How to Replace a Node-to-Switch Component in a Cluster That Uses Multipathing
How to Replace a Node-to-Switch Component in a Cluster Without Multipathing
This chapter contains the procedures about how to install, configure, and maintain a Sun StorEdge 6120 array in dual-controller configurations and in single-controller configurations. These procedures are specific to a Sun StorEdge 6120 array in an Oracle Solaris Cluster environment.
This chapter contains the following main topics: