Using the Command Line Interface to Add Terminals

The following procedure is required to set up a terminal on ttya port via the command line:

1. Determine the port monitor version number.

   The port monitor version number will display.

   # ttyadm -V

2. Enter the following commands, substituting the port monitor version number for ver.

   (For more information on sacadm (1M) and pmadm (1M) , see their man pages.)

   # pmadm -r -p zsmon -s ttya # sacadm -a -p zsmon -t ttymon -c /usr/lib/saf/ttymon -v ver

3. Use the pmadm command that matches your terminal type to add a login service:

   For EUC terminals, use the following command:

   # pmadm -a -p zsmon -s ttya -i root -fu -v ver -m "`ttyadm -S y \ -T terminal_type -d /dev/ttya -l 9600 -m ldterm,ttcompat -s \ /usr/bin/login`"

4. Turn on the terminal.

   Follow the documentation that accompanies the terminal.

5. Log in the terminal.

6. Check the correctness of the installation:

   # setenv LANG locale # /bin/stty cs8 -istrip defeucw

   ---

   Note -

   These values show that the operating system is set to communicate with the terminal in "8-bit no-parity" mode. Make sure the terminal is set up in "8-bit no-parity" mode. Refer to the terminal's setup manual for the proper way to set terminal options.

   ---