C H A P T E R  3

Feedback Documentation Errata

This chapter provides the following information about Oracle’s Sun Blade T6340 server module documentation:


Correction to the Service Manual

The following erratum applies to Sun Blade T6340 Server Module Service Manual.

Replace section 2.6.4.3 “Clearing Faults Manually with ILOM” in the service manual with the following text:

The ILOM . . .


set /SYS/component clear_fault_action=enabled 

. . . command allows you to manually clear certain types of faults without replacing a FRU. It also allows you to clear a fault if ILOM was unable to automatically detect the FRU replacement.

A kernel panic can occur under any of four rare hardware error conditions:

If any of these errors occur, then a software initiated reboot of the domain will fail.

The failure symptom will be no that there is no PCI device in the OpenBoot PROM device tree. OpenBoot software will not be able to boot the domain automatically.

Workaround: Power the system off then power it on again from the service processor. This action permits the automated reboot to proceed normally. A diagnostic process will run, identifying any faulty hardware.

Feedback