Specify the Hello Messaging Interval

Document Information

Using This Documentation

Product Notes

Related Documentation

Acronyms and Abbreviations

CLI Command Modes

Feedback

Support and Accessibility

Reducing Data Transmission Time Using the SPT

Specify the PIM Threshold That Triggers SPT Switching

Specify the PIM SPT Switch Period

Specify the PIM RP Threshold That Triggers Source-Specific Switching

Specify the PIM RP Switch Period

Monitor the Data Transfer Rate After a Register Stop Message

Configuring PMBR Status

Enable PMBR Status Reporting

Disable PMBR Status Reporting

Enabling Static RP Configurations

Enable Static RP

Disable Static RP

Associate an Interface to a PIM Component

Delete a PIM Interface

Configuring Designated Routers

Prioritize Router Messaging With PIM DR-Priority

Restore the Default Router Priority Designation

Configuring the PIM Override Interval

Specify the Interval to Delay Override Messages

Restore the Default Override Messaging Interval

Configuring PIM LAN Delay

Delay LAN Message Propagation

Restore the Default LAN Delay Interval

Configuring LAN Prune Delay

Enable LAN Prune Delay

Disable LAN Prune Delay

Configuring BSR Candidates

Prioritize BSR Candidates

Restore the Default BSR-Candidate Value

Configuring PIM Query Intervals

Specify the Hello Messaging Interval

Restore the Default Hello Messaging Interval

Configuring PIM Join and Prune Messaging

Specify the Join and Prune Messaging Interval

Restore the Default Message Interval

Managing PIM Components

Create a PIM Component

Delete a PIM Component

Configuring PIM Component Data Routing Modes

Specify a Data Routing Mode

Configuring RP-Candidate Behavior

Specify the Address for the Candidate RP

Delete an RP Candidate

Configuring RP Candidate Hold Time

Specify RP Candidate Hold Time

Restore the Default Candidate RP Hold Time

Configuring Static RPs

Specify the Address for the Static RP

Delete a Static RP

Display RP Details

Enable PIM Neighbor Recognition

Display PIM Multicast Information

This example transmits hello messages from VLAN 5 to neighboring PIM routers every 80 seconds.

Enable PIM globally.

SEFOS# configure terminal
SEFOS(config)# set ip pim enable

Enter Interface Configuration mode for the interface.
```
SEFOS(config)# interface vlan 5
```
Associate the VLAN interface with the PIM component.
```
SEFOS(config-if)# ip pim componentId 1
```

Configure the query interval for the PIM interface.

SEFOS(config-if)# ip pim query-interval 80
SEFOS(config-if)# end

Ensure that the correct PIM query interval is set.

SEFOS# show ip pim interface detail
Vlan5 33 is up
 Internet Address is 10.1.0.1
Muticast Switching : Enabled
PIM : Enabled
PIMv6 : Disabled
PIM version : 2, mode: Sparse
PIM DR : 10.1.0.1
PIM DR Priority : 1
PIM Neighbour Count : 0
PIM Hello/Query Interval : 80
PIM Message Interval : 60    
PIM Override Interval : 0
PIM Lan Delay : 0
PIM Lan-Prune-Delay : Disabled
PIM Component Id : 1
PIM domain border : disabled

Skip Navigation Links
Exit Print View
	Sun Ethernet Fabric Operating System PIM Administration Guide

PIM Administration Guide

Specify the Hello Messaging Interval