Skip Navigation Links | |
Exit Print View | |
![]() |
Sun Ethernet Fabric Operating System PIMv6 Administration Guide |
Configuring the Topology Example
Enable IPv6 Support and Assign IPv6 Addresses
Configure the Group and Source Thresholds
Configure the SPT Switching Period
Configure the Rendezvous Point Threshold
Configure the RP Switch Period
Configure the regstop Rate Limit
Configuring PIMv6 on an Interface
Associate the PIMv6 Component to an Interface
Configure the Query-Interval Value
Configure the DR Priority Value
Configure the Override Interval
Configure the Message Interval
Configuring the PIMv6 Component
Set the Mode for the PIMv6 Component
Configure the RP-Candidate Hold Time
Configure the RP-Candidate Address
This section contains procedures for configuring the Oracle's SEFOS PIMv6 features. The configurations are global to all of the components in a router. Some of these procedures have the default values shown in Default Settings. You do not need to reconfigure these values unless your administration requirements are different.
Note - In some procedures in this section, the example output has been truncated for readability.