Connecting the Server to the Network

1. If you have the rack-ready version of the Netra 150 server, install it in the rack if you haven't already done so.

   Refer to the Model 150 Series Rack-Ready Installation Manual for those instructions.

2. Verify that the Netra 150 server power switch is in the OFF (O) position (Figure 1-2).

   Figure 1-2 Connecting the Netra 150 Server to the Network

   
   

3. Connect the power cord to the AC power receptacle at the rear of the Netra 150 server (Figure 1-2).

4. Connect a network cable from the Internet connection to one of the two Ethernet ports at the rear of the Netra 150 server (Figure 1-2).

5. Verify that an external fast wide SCSI cable is connected between the appropriate SCSI ports as shown in Figure 1-3.

   Figure 1-3 Connecting the SCSI Cable

   
   

6. Determine if you have any other connections to make.

   • If you want to connect an external peripheral to your Netra 150 server, go to "Connecting an External Peripheral".

   • If you want to connect a monitor and keyboard to your Netra 150 server, go to "Connecting a Monitor and Keyboard".

   • If you want to connect a TTY terminal to your Netra 150 server, go to "Connecting a TTY Terminal".

   • If you have no other connections to make, go to "Performing the Initial Configuration".