About This Documentation (PDF and HTML)
Hardware Installation and Product Notes
Overview of the Sun Blade X6275 M2 Server Module
Server Module Front Panel and Indicators
Installing and Powering On the Server Module
About Your Server Module Shipment
Finding the Serial Number and Accessing Warranty Support Information
How to Install Your Server Module
How to Apply Full Power to a Server Module Node
How to Power Off a Server Module Node
Troubleshooting Server Power States
How to Display the ILOM IP Address Using the Web Interface
How to Display the ILOM IP Address Using the CLI
How to Log In to the ILOM Web Interface Using an Ethernet Connection
How to Log In to the ILOM CLI Using an Ethernet Connection
How to Log Into ILOM Using a Serial Connection
Configuring an ILOM IP Address
How to Configure a DHCP IP Address
Accessing the Host Console Through ILOM
How to Connect to the Host's Serial Console Using the ILOM Command-Line Interface
How to Connect to the Host Console Using the ILOM Web Interface
Overview of the Sun Blade X6275 M2 Server Module Product Notes
System Software Release Features
Hardware, Firmware, and BIOS Issues
Installing the Oracle Solaris Operating System
Installing Red Hat Enterprise Linux
Installing the SLES Operating System
Introduction to Oracle VM Installation
Creating a PXE Installation Image for Oracle VM
Introduction to Windows Installation
Getting Started With Windows Server 2008 Installation
Installing the Windows Server 2008 R2 Operating System
Updating Critical Drivers and Installing Supplemental Software
Incorporating Device Drivers into a WIM Image for WDS
Administration, Diagnostics, and Service
Overview of the ILOM Supplement
Managing Power Usage and Monitoring Power Consumption
Configuring the Server Power Restore Policy
Switching the Default Serial Port Output Between SP and Host Console
Indicators, Sensors, and Traps
Introduction to Diagnostic Tools
U-Boot Diagnostic Startup Tests
Accessing the Pc-Check Diagnostics Utility on the Tools and Drivers CD/DVD
Server Module and Components Overview
Preparation Procedures for Service and Operation
Component Removal and Installation Procedures
If you plan to assign a static IP address to a server node's ILOM service processor, perform the following procedure.
For example:
$ ssh username@CMMIPaddress
where username is a user account with administrator privileges and the CMMIPaddress is the IP address of the CMM ILOM.
Tip - The default ILOM administrator account user name is root and the password is changeme. If this default administrator account has been changed, contact your system administrator for an ILOM user account with administrator privileges.
Substitute the static IP address and the network configuration information to be changed. To see the current configurations, use the show command in /CH/BL4/NODE0/SP/network.
For example, you might enter the following commands:
-> cd /CH/BL4/NODE0/SP/network -> set pendingipaddress=129.144.82.26 -> set pendingipnetmask=255.255.255.0 -> set pendingipgateway=129.144.82.254 -> set pendingipdiscovery=static -> set commitpending=true
For example, if you have already configured NODE0, you would then enter the commands to configure NODE1.
-> exit
See Also