Sun Blade X3-2B Model Name Change
Getting the Latest Firmware and Software
About the Chassis Monitoring Module (CMM)
Replaceable Server Module Components
Preparing the Sun Blade X3-2B for Service
Obtaining the Server Module Serial Number
Powering Off the Server Module
Performing ESD and Antistatic Prevention Measures
Remove the Server Module from the Sun Blade Chassis
Remove the Server Module Top Cover
Removing or Inserting Filler Panels
Servicing Sun Blade X3-2B Components
Servicing a Storage Drive (CRU)
DIMM Population Rules and Guidelines
Remove Optional DIMM Filler Panels
Install Optional DIMM Filler Panels
Replace the System Battery (CRU)
Servicing USB Flash Drives (CRU)
Servicing a Fabric Expansion Module (CRU)
Servicing a RAID Expansion Module (CRU)
Servicing a Processor and Heat Sink Assembly (FRU)
Servicing the Motherboard Assembly (FRU)
Returning Sun Blade X3-2B to Operation
Install the Server Module Top Cover
Install the Sun Blade X3-2B in the Chassis
Troubleshooting the Sun Blade X3-2B
Diagnosing Server Module Hardware Faults
Troubleshooting Using LED Status Indicators
Using the DIMM and Processor Test Circuit
Troubleshooting Server Module Power States
Firmware and Software Troubleshooting
BIOS Power-On Self-Test (POST) Checkpoints
About POST Code Checkpoint Memory Testing
POST Code Checkpoint Reference
Getting Server Firmware and Software
Firmware and Software Access Options
Available Software Release Packages
The following topics describe the components of the Fault Remind circuitry.
Note - Do not press the white Clear CMOS Button (SW1801).
The blue Fault Remind button (SW3001) is located on the motherboard next to the Charge Status LED (CR3002). The Charge Status LED indicates the usability of the processor test circuit. When the Fault Remind button is pressed, the Charge Status LED, lights green to indicate that there is sufficient voltage present in the fault remind circuit to activate the fault LEDs. DIMM Fault LEDs identify DIMMs in a fault state.
Note - Press the fault remind circuitry within 15 minutes of removing the server from the chassis. If the green Charge Status LED fails to light when you press the Fault Remind button, it is likely that the fault remind circuit has lost its charge.
The DIMM Fault LEDs are located on the on the motherboard next to each DIMM slot. The amber LEDs light up when the Fault Remind button is pressed and a DIMM fault condition exists.