Sun T1000 and T2000 Requirements

By default the Sun T1000 and T2000 systems run a server that uses port 9010. ATG’s lock management components also use this port. If you are using lock management, you must either disable the server or change your lock manager to use a different port.

To disable the server:

  1. Log in as root.

  2. Enter the following command:

    mv /etc/rc2.d/S95IIim /etc/rc2.d/K95IIim

  3. Stop the service:

    /etc/rc2.d/S95IIim stop

To change ATG lock manager port assignments, when you configure your lock management components, use the following settings:

  1. For the ClientLockManager port assignment in <ATG9dir>/home/localconfig/atg/dynamo/service
    /ClientLockManager.properties:

    useLockServer=true
    lockServerPort=39010

  2. For the ServerLockManager port assignment in <ATG9dir>/home/servers/servername/localconfig/atg/dynamo/service
    /ServerLockManager.properties:

    port=39010

See the Locked Caching section of the ATG Repository Guide for information on configuring lock managers.

 
loading table of contents...