How to Configure Sybase ASE Database Access With Solaris Volume Manager
-
Configure the disk devices for the Solaris Volume Manager software to use.
For information about how to configure Solaris Volume Manager, see Oracle Solaris Cluster Software Installation Guide .
-
If you use raw devices to contain the databases, run the following commands to change each
raw-mirrored metadevice's owner, group, and mode.
If you do not use raw devices, do not perform this step.
-
If you create raw devices, run the following commands for each device on each
node that can master the Sybase ASE resource group.
# chown sybase /dev/md/metaset/rdsk/dn
# chgrp dba /dev/md/metaset/rdsk/dn
# chmod 600 /dev/md/metaset/rdsk/dn
- metaset
-
Specifies the name of the disk set
- /rdsk/dn
-
Specifies the name of the raw disk device within the metaset disk
set
-
Verify that the changes are effective.
# ls -lL /dev/md/metaset/rdsk/dn
Next Steps
Go to How to Create the Sybase ASE Database
Environment.