Set Up a Local Storage Drive (HDD, SSD, or RAID Volume) as the Installation Target

1. Ensure that the target hard disk drive (HDD) or solid state drive (SSD) is properly installed and powered on.

   For more information about installing and powering on a HDD or SSD, refer to Servicing Storage Drives and Rear Drives (CRU) in Oracle Server X6-2L Service Manual.

2. Ensure that the target drives are configured to suit your environment.

   By default, each physical drive on the server is configured as a logical RAID 0 volume. To implement an alternative configuration, refer to the following resources:

   • Configuring Storage Drives for Operating System Installation in Oracle Server X6-2L Installation Guide

   • Oracle X6 Series Servers Administration Guide at: http://www.oracle.com/goto/x86admindiag/docs