Enabling Panel Selector Arrows on a Panel Stack

Once you have created a panel stack with multiple panels, you can allow users to change the panel displayed in the panel stack.

You can:

Create a selector with the panel stack as its target. Users can select a panel in the selector to change the panel displayed in the panel stack. For steps to create a selector for a panel stack, see Creating a selector for a panel stack.
Enable the Previous and Next arrows in the panel stack's title bar, to allow users to display the next or previous panel in the panel stack, as shown below. The arrows are displayed in Interactive Mode and Flash Mode. Steps are below to enable the Previous and Next arrows.

Note: These instructions apply to panel stacks and to filter panels, which are a type of panel stack that contains only selectors.

Prerequisites

This procedure assumes that you have already created the document with the panel stack you want to display.
The panel stack must have at least two panels.

To enable or disable the panel selector arrows for a panel stack

Open the document in Design or Editable Mode.
Right-click the panel stack, then select Properties and Formatting. The Properties and Formatting dialog box opens.
From the left, click General.
Do one of the following:
- To display the panel selector arrows, select the Allow current panel to be changed without selector check box.
- To hide the panel selector arrows, clear the Allow current panel to be changed without selector check box.
  
  Note: Hiding the panel selector arrows disables changing panels in iPad documents by horizontal swiping.
Click OK to save your changes and return to the document.