Go to main content

Oracle^® Server X7-2 Product Notes

Exit Print View

» ...Documentation Home » Oracle Server X7-2 Documentation Library » Oracle^® Server X7-2 Product Notes » Hardware Issues » Lockstep Memory (Channel) Mode Is Not Supported

Updated: July 2020

Oracle^® Server X7-2 Product Notes

Document Information

Using This Documentation

Oracle Server X7-2 Product Information

Software and Critical Patch Updates

Issues Fixed in Software Releases

Hardware Issues

Oracle Dual Port 10/25GbE Ethernet Controller-LOM Firmware 214.2.271.5

10GBASE-T RJ-45 GbE Ports Are Not Operating And LEDs Remain Dark After Port Switch and Power Cycle

Diagnosing SAS Data Path Failures on Servers Using MegaRAID Disk Controllers

Failure of a Single Server Fan Module Might Impact Performance

Remove and Replace a Fan Module Within 20 Seconds

Lockstep Memory (Channel) Mode Is Not Supported

MAC Address Mapping to Ethernet Ports

Do Not Install an Avago 10G SR Optical Transceiver Into an SFP28 Port

Do Not Mix Single-Rank and Dual-Rank DIMMs

Oracle Dual Port 25 Gb Ethernet Adapter Can Experience a Fault During System Reset

Oracle Storage 12 Gb SAS PCIe RAID HBA Can Cause the System to Hang During Reboot

Oracle ILOM Issues

Oracle Solaris Issues

VMware ESXi Issues

Documentation Issues

Getting Firmware and Software Updates

Language:

Lockstep Memory (Channel) Mode Is Not Supported

Important Operating Note

Your Oracle Server X7-2 does not support lockstep memory mode, which is also known as double device data correction, or Extended ECC.

Copyright © 2017, 2020, Oracle and/or its affiliates.