Connect the RJ-45 Ethernet Cables

1. Identify the prerequisite and subsequent installation tasks that you must perform in conjunction with this task.

   See Installation Task Overview.

2. If the rack rear door is installed, open it.
3. Attach the cable to the appropriate connector of the node or host.
4. Route and bundle the data cables through the physical topology.
5. Bring the cable to the location in the rack where the module is installed.
6. Orient the RJ-45 connector to where it will connect to the module.
7. Slowly move the connector in, and continue to push the connector in until you feel a detent or click.
8. Repeat Step 3 to Step 7 for any other cables to be connected.
9. If the rack rear door is installed, close and secure it.
10. Verify the module installation.

    See Verify Module Installation.

Related Information

• ESD Precautions

• Order Additional Hardware

• Supported Cables

• Remove the Filler Panel

• Install the Module

• Verify Module Installation