Media Interface Virtual MAC Addresses

To configure HA for the media interfaces in an HA node, you must set one or more virtual MAC addresses, according to the type of physical layer cards you have installed on your Oracle® Enterprise Session Border Controller.

To set a virtual MAC address using the ACLI:

1. Access the phy-interface configuration.
2. Configure all relevant parameters as noted in the Phy-Interfaces section of this guide’s System Configuration chapter.

   Since virtual MAC addresses are used for media interfaces only, verify that the operation type is set to media.

3. virtual-mac—Enter the virtual MAC address that you have created using the steps in the Virtual MAC Addresses section.