Pre-Configuration Requirements for the Microsoft Windows Embedded POSReady 2009 Wireless WS5A

This section explains the steps necessary to connect a Microsoft Windows Embedded POSReady 2009 Wireless WS5A for PCI compliance. When configuring, use the highest encryption level available to the device. It is recommended that the WS5A always be used at a minimum of WPA2-AES.

Before you can connect the Microsoft Windows Embedded POSReady 2009 Wireless WS5A to a wireless network, make sure to:

1. Read the PCI DSS Wireless Guideline Informational Supplement version 2.0.

2. Verify that the WS5A has minimum CAL version 13.1.3.68 installed. If CAL needs to be updated, contact your Oracle MICROS representative.

3. Verify that the Mini-PCI Wireless Card was installed on the WS5A. This must be installed before connecting the Wireless WS5A to a wireless network. If you need to request this part, reference the following part number (PN) and description:

   • PN: 400633-220-PT

   • Description: : KIT, MINI-PCI UPGRADE, WS4LX, WS5, WS5A. Note that this card is capable of using WPA2 encryption with AES. Its configuration is PCI compliant when using WPA2 encryption and placed behind a Firewall.

   The Installing the Workstation 5/5A Mini-PCI Wireless Kit document contains installation instructions.

4. Ensure that your site has a WPA2-AES compatible Access Point.

5. If using PEAP, have an Authentication device (for example, IAS Server or the WS2000).

6. Have a USB keyboard for the workstation.