SM8G-B 64-bit to 32-bit Conversion

The following procedure is used to convert the 64-bit mode to 32-bit. The target card must already be running on the BLDC64 GPL and contain the correct bootloader, as completed in SM8G-B Bootloader Swap. Skip this procedure if the card is already running the BLMCAP GPL.

1. Inhibit the target card with the inh-card:loc=<card_loc>:force=yes.
   The card will boot and return to state OOS-MT-DSBLD within 60 seconds.
2. Flash the card with the init-flash:loc=<card_loc>:code=appr:mode=cnvrtbit:bits=32 command.
   After the flashing operations complete, the card will boot and return to state OOS-MT-DSBLD.
3. Activate the new BLMCAP GPL with the act-flash:loc=<card_loc> command.
   The card will now run on 32-bit mode and will accept 32-bit mode applications from the OAM.