Go to main content

Oracle® Server X8-2L Service Manual

Exit Print View

Updated: October 2019
 
 

Install the Temperature Sensor

  1. Install the temperature sensor by carefully inserting the sensor-end of the cable through the rear opening of the cable trough. Then pull the cable through the opening and install it into the cable trough along the left side of the chassis [1].
    image:Figure showing the temperature sensor being installed into the                             chassis.
  2. Install the FIM cable and Temp Sensor Access cover to the chassis by inserting it into the FIM cable and Temp Sensor Access cover slot [2].
  3. Install the three No. 2 Phillips screws to secure the FIM cable and Temp Sensor Access cover to the chassis [3].
  4. Reconnect the temperature sensor cable to the disk backplane.
    image:Figure showing the temperature sensor cable being connected to the                             disk backplane.
  5. Install the fan tray and fan modules.

    See Install the Fan Tray and Install a Fan Module.

  6. Return the server to operation.
    1. Install the server top cover.

      See Install the Server Top Cover.

    2. Return the server to the normal rack position.

      See Return the Server to the Normal Rack Position.

    3. Reconnect the power cords to the power supplies, and power on the server.

      See Reconnect Power and Data Cables and Power On the Server.

    4. Verify that the power supply AC OK LED is lit.

Related Information