Increasing Data Capacity with 480G Drive Modules

If 300G drive modules were in use when EPAP was installed, EPAP must be re-installed to take advantage of the additional storage capacity available on 480G drive modules.

Procedure - Increase Data Capacity with 480G Drive Modules

1. Backup the data and configurations of the existing setup.
   Follow the steps in 3.2 Pre Full Upgrade Steps and 3.3 Data Backup before Full Upgrade in Full Upgrade Guide.
2. If you have not already replaced both 300G drive modules with 480G drive modules, remove the 300G drive modules from the E5-APP-B card.
   See Removing a Drive Module Assembly.
3. If you have not already replaced both 300G drive modules with 480G drive modules, insert the new 480G drive modules.

   See steps 1 through 4 in Replacing a Drive Module Assembly.

4. After the drive modules are successfully replaced, IPM the drive modules with the latest TPD and install EPAP.
   Follow the steps in 3.4 IPM and EPAP 16.1 Installation in Full Upgrade Guide.
5. Perform initial configuration and data migration to complete the procedure.
   Follow the steps in 3.5 Initial Configuration on EPAP and 3.6 Data Migration in Full Upgrade Guide.