Single-POV Calculation Steps

Caution:

Before calculating an application, ensure that cost and revenue data have been loaded. Otherwise, the calculation uses an empty data set.

To clear or calculate an application using a single POV:

1. On the Home page, click Models, , and then Execution Control, .

   The Execution Control screen opens.

   Figure 3-1 Execution Control Screen with a Single POV Selected

   
   
   
2. Select a POV that has model data (Model Exists is checked).
   Here, the selected POV is for January 2016 with Actual data and a status of Draft.
3. Click Run Calculation to calculate that POV.

   The Run Express Calculation screen opens.

   Figure 3-2 Run Express Calculation Screen with a Single Model POV Selected

   
   
   

   Because you selected a single POV with both data and rules, that POV is entered by default into the Select Model Point of View boxes.

   Note:

   A POV with rules is called a model POV. You can select any POV with a check in the Model Exists column of the previous screen (Execution Control).

4. For this example, leave the default POV and all other defaults as entered. Enter a descriptive comment in the Job Comment box, as shown, to identify this job in the Job Library.

   To learn more about the other settings, see Enter Calculation Settings.

5. Click Run to run the calculations or clear data immediately. A confirmation message indicates that the job has started and identifies the assigned taskflow ID.

   Caution:

   Depending on the size and complexity of an application, this operation may take a significant amount of time.

6. Monitor the progress of the calculation using the taskflow ID in the Job Library (View the Job Library).