Prompt-location screen flows
- In the RF Receive by Shipment or RF Receive by Load modules, when you configure the screen parameter “prompt-location” as Do not prompt, the location prompt is not displayed after receiving is complete.
- In the RF Receive by Shipment or RF Receive by Load modules, when the screen
parameter “prompt-location” is configured as Prompt if not known, location
prompt is displayed after receiving is complete. You can enter a reserve, active, or
dock location or skip entering any location by using Ctrl+W or
Ctrl+X.
- Location prompt is not displayed after receiving is complete:
- If a dock door is scanned at the beginning of receiving. Instead the LPN will be located to the scanned dock door.
- If the shipment/load is associated to an appointment that has been checked into a dock. Instead the LPN will be located to the dock door where the shipment/load was checked in through appointment.
- If the screen parameter “next-screen-to-launch” is configured as rf.inbound.cwrfibsortlpn (Inbound Sorting).
- If cross dock is enabled in the receiving module, and cross dock completes successfully.
- After receiving an LPN, if the QC Status of LPN is Marked for QC, then
location display is driven by the screen parameter “qc-handling-mode”.
- If the screen parameter “qc-handling-mode” is configured as Mark for QC prompt QC locn, the QC location prompt is displayed.
- If the screen parameter “qc-handling-mode” is configured as Mark for QC do not prompt QC locn, the location prompt is not displayed.
- If you enter an active location, the system throws the error “Cannot putaway
to location type A” if:
- Flow through allocation (MHE) is enabled and flow through allocation is successful.
- You have received Pallet through “Palletize Upfront” or “Palletize after receipt” or “LPN or Pallet receiving.”
- Location prompt is not displayed after receiving is complete:
In the above two scenarios, you only have the option to enter a Reserve or Dock location.