Screen Flow when confirm-uom-qty is Configured as Do Not Prompt
When the screen parameter “qty-uom” is configured as Cases or
Packs and the screen parameter “confirm-uom-qty” is configured as
Do Not Prompt, the Ctrl Q key is displayed on the SKU scan screen.
This key is functional only after a SKU is scanned on the screen. After a SKU is
scanned and Ctrl Q is invoked, a pop up is displayed on the screen. This pop-up
shows the current std case/pack qty of the scanned SKU as configured in item
master. The pop up also has the option to change the std case/pack qty of the
SKU.
If the std case/pack qty is changed on the pop-up, the new value is displayed as
the case/pack qty on the SKU scan screen.
The new std case/pack qty will be applicable for the SKU in the LPN and
subsequent LPNs throughout the receiving session until you exit from the
receiving module.
During the same session, you have the option to change the case/pack qty
for the same SKU in a different LPN.
You cannot change the case/pack qty of a SKU in the same LPN twice. If
you attempt to change it a second time, the message “SKU already scanned
with case/pack qty X is displayed.”
If you receive the first SKU without using Ctrl-Q, then the std
case/pack qty from item master is used and will be applicable for the
SKU in the LPN and subsequent LPNs. In general, once a std/pack qty has
been used for a SKU in an LPN, it cannot be changed in the same LPN.
Note:
If the std case/pack qty is changed on the receiving SKU
scan screen, it does not reflect back on item master.