4.53 chg-eisopts

Use this command to enable and disable the copy functions that are associated with the EAGLE 5 Integrated Monitoring Support (E5IS) feature.

Parameters

eiscopy (optional)
System-wide control for MSU, alarm, and event copy to the ESP.
Range:
on
off
Default:
No change to the current value
System Default:
off
fcgpl (optional)
This parameter applies the functionality specified by the fcmode parameter to cards running the specified Fast Copy GPL.
Range:
all
apply functionality to cards running the IPSG GPL
ipsg
apply functionality to cards running the IPSG GPL
Default:
No change to the current value
System Default:
all
fcmode (optional)
This parameter specifies a system-wide control to enable or disable monitoring on FC-capable cards.
Range:
fcopy
FC monitoring is performed on FC-capable cards
off
Monitoring is not performed on FC-capable cards
stc
STC monitoring is performed on FC-capable cards
Default:
No change to the current value
System Default:
stc
If Integrated Monitoring is turned on for the first time, and the eiscopy=on parameter has been specified, then the system default for the fcmode parameter is stc . If the eiscopy=off parameter has been specified, then the system default value is off .

Example

chg-eisopts:eiscopy=on

chg-eisopts:fcmode=fcopy:fcgpl=all

Dependencies

At least one parameter must be specified.

The E5IS feature must be turned on before this command can be entered

The NETOPTS table must be accessible.

Before the E5IS copy function can be enabled, at least 2 STC cards must be installed and in the IS-NR state in the system.

The eiscopy=on parameter must be specified before a value of stc or fcopy can be specified for the fcmode parameter.

The fcmode=off parameter must be specified before the eiscopy=off parameter can be specified and before the value of the fcmode parameter can be changed between stc and fcopy .

At least one card must be running the IPSG GPL and must be in the IS-NR state before a value of ipsg or all can be specified for the  fcgpl parameter.

If the fcgpl parameter is specified, then the fcmode parameter must be specified.

The host portion of the PVN network address must be 0 based on the PVN subnet mask (see the  chg-netopts command) before the eiscopy=on parameter can be specified.

The destination of a static IP route (see the ent-ip-rte command) and the local interface network address of an IP card (see the  ent-ip-host command) must be different from the PVN, FCNA, and FCNB network addresses (see the  chg-ip-lnk command) before the eiscopy=on parameter can be specified.

The FCMODE cannot be changed to FCOPY due to Signaling Link(s) provisioned on Port C or Port D.

If the same value is specified for the PVN, FCNA, or FCNB network addresses (see the chg-netopts command), then the  eiscopy=on parameter cannot be specified.

Notes

Fast Copy Cards

E5-ENET-B cards running the IPSG GPL are considered to be FC- capable. An FC- capable card is considered FC- enabled when Fast Copy monitoring is enabled for the respective GPL.

Output

chg-eisopts:fcmode=fcopy:fcgpl=all

    rlghncxa03w 10-02-02 09:08:58 EST  EAGLE 42.0.0
    CHG-EISOPTS: MASP A - COMPLTD