4.143 chg-ss-appl
Use this command to change the application status in the database.
Parameters
Example
chg-ss-appl:appl=lnp:nstat=offline
chg-ss-appl:appl=atinpq:nstat=online
chg-ss-appl:appl=inp:nstat=offline:nrqdtblnop=disc
Dependencies
The LNP feature must be turned on before the appl=lnp parameter can be specified.
The INP feature must be turned on before the chg-ss-appl:appl=inp
command can be entered.
The Equipment Identity Register (EIR) feature must be turned on before the chg-ss-appl:appl=eir
command can be entered.
The application type (appl parameter) must already exist in the SS-APPL table.
The LNP database is corrupt or cannot be found.
The subsystem must be in the opposite state of the requested change.
The subsystem must be inhibited before status=offline can be specified.
Application type must exist in the LNP database
Application type not in SS-APPL table
The SSAPPL table must be accessible (non-DBS 1.0 systems only).
The SSAPPL table must be accessible (DBS 1.0 systems only)
The V-Flex feature must be turned on before the appl=vflex parameter can be specified.
The ATINP feature must be enabled before the appl=atinpq parameter can be specified.
The ANSI41 AIQ feature must be enabled before the appl=aiq parameter can be specified.
The EPAP Data Split feature OR Dual ExAP Config feature must be turned on before the nrqdtblnop parameter can be specified.
If the appl=aiq parameter is specified, then the nrqdtblnop parameter cannot be specified.
Notes
After the LNP subsystem is inhibited before performing an LNP ELAP bulk download, chg-ss-appl:appl=lnp:nstat=offline
must be entered to ensure that the subsystem remains down through Service Module card replacements and reloads.
Output
chg-ss-appl:appl=aiq:nstat=offline
tekelecstp 09-12-03 13:35:40 EST EAGLE 42.0.0
CHG-SS-APPL: MASP A - COMPLTD
;