4.265 dlt-ss-appl

Use this command to remove the application from the database.

Parameters

appl (mandatory)
Application type.
Range:
lnp
inp
eir
vflex
atinpq
aiq
sfapp

Example

dlt-ss-appl:appl=inp

Dependencies

The LNP feature must be turned on before the appl=lnp parameter can be specified.

The INP feature must be turned on before the dlt-ss-appl:appl=inp command can be entered.

The Equipment Identity Register (EIR) feature must be turned on before the dlt-ss-appl:appl=eir command can be entered.

The value specified for the appl parameter must already exist in the SS-APPL table.

The LNP database and the SS-APPL table are corrupt or cannot be found.

The subsystem must be inhibited before status=offline can be specified. This condition is not true in the case of SFAPP, as the status is not changed to offline for SFAPP, but the entry is deleted.

Application type must exist in the LNP database (non DBS 1.0 only)

Unable to access database.   Severe database failure.

Failed reading SSAPPL table. (non-DBS 1.0 systems only)

The V-Flex feature must be turned on before the appl=vflex parameter can be specified.

The ATINP feature must be enabled before the appl=atinpq parameter can be entered.

The ANSI41 AIQ feature must be enabled before the appl=aiq parameter can be specified.

Notes

When a subsystem application is deleted, the following message is displayed:

CAUTION: DELETED APPL SSN MAY BE REFERENCED BY GTT ENTRY

Output

dlt-ss-appl:appl=aiq

    tekelecstp 09-12-03 17:34:20 EST  EAGLE 42.0.0
    DLT-SS-APPL: MASP A - CAUTION: DELETED APPL SSN MAY BE REFERENCED BY GTT ENTRY
    DLT-SS-APPL: MASP A - COMPLTD 
;