4.166 conn-imt

Use this command to connect a manually disconnected card to the specified IMT bus. The card must have been manually disconnected from the bus previously by the disc-imt command. If the card was disconnected from the bus for other reasons, this command has no effect.

Parameters

bus (mandatory)
IMT bus to which the specified card is to be connected.
Range:
a
b
loc (mandatory)
The card location as stenciled on the shelf of the system.
Range:
1101 - 1108, 1111 - 1112, 1201 - 1208, 1211 - 1218, 1301 - 1308, 1311 - 1318, 2101 - 2108, 2111 - 2118, 2201 - 2208, 2211 - 2218, 2301 - 2308, 2311 - 2318, 3101 - 3108, 3111 - 3118, 3201 - 3208, 3211 - 3218, 3301 - 3308, 3311 - 3318, 4101 - 4108, 4111 - 4118, 4201 - 4208, 4211 - 4218, 4301 - 4308, 4311 - 4318, 5101 - 5108, 5111 - 5118, 5201 - 5208, 5211 - 5218, 5301 - 5308, 5311 - 5318, 6101 - 6108, 6111 - 6118

Example

conn-imt:loc=1201:bus=a

Dependencies

The card being reconnected must first be disconnected manually from the bus by using the disc-imt command.

This command cannot be entered during an IMT Fault Isolation Test or an Extended Bit Error Rate Test (BERT).

The card location, frame, shelf, or slot must be within the allowed range.

Valid IMT bus entries are "A" or "B".

Notes

This command has no effect if the card was disconnected from the IMT bus in any way other than manually using the disc-imt command.

Output

conn-imt:loc=1201:bus=a

    rlghncxa03w 04-01-07 11:02:30 EST  EAGLE 31.3.0
    Connect IMT Bus A command issued to card 1201

    rlghncxa03w 04-01-07 11:02:30 EST EAGLE 31.3.0
    0100.0006 IMT Bus A Card connected to IMT

    rlghncxa03w 04-01-07 11:02:30 EST EAGLE 31.3.0
    3112.0006    CARD 1201 CCS7ITU     Card connected to IMT 
;