3.6.7 Procedure 21 POST FULL UPGRADE SYSCHECK

Table 3-25 Procedure 21 POST FULL UPGRADE SYSCHECK

STEP #	This procedure runs an initial system check to validate the software install and system readiness. Note: Estimated time of completion is 5 minutes. Check off (✓) each step as it is completed. Boxes have been provided for this purpose under each step number. Should this procedure fail, Contact Oracle technical services and ask for FULL UPGRADE ASSISTANCE.
1. ☐	MPS A: Login as root.	login: root Password: <root_password>
2. ☐	MPS A: Issue the command to retrieve the system status	# syscheck
3. ☐	MPS A: The syscheck response is displayed. Verify all components are “OK” on the mate ELAP NOTE: Investigate the cause of any failure in the syscheck response. Correct the issue or contact Support for resolution before proceeding.	Running modules in class disk... OK Running modules in class hardware... OK Running modules in class net... OK Running modules in class proc... OK Running modules in class services... OK Running modules in class system... OK Running modules in class upgrade... OK LOG LOCATION: /var/TKLC/log/syscheck/fail_log
4. ☐	MPS A: Issue the command to retrieve the system status on the mate ELAP	# ssh admusr@mate 'sudo syscheck'
5. ☐	MPS A: The syscheck response is displayed. Verify all components are “OK” on the mate ELAP	Running modules in class disk... OK Running modules in class hardware... OK Running modules in class net... OK Running modules in class proc... OK Running modules in class services... OK Running modules in class system... OK Running modules in class upgrade... OK LOG LOCATION: /var/TKLC/log/syscheck/fail_log
6. ☐	MPS A: Note down the timestamp in log.	Run the following command: $ date

This procedure is complete!