Closing Config ID
After you finish a set of configurations for a customer in
Non-production tenancy and is ready for further testing in Pre-production tenancy, close
the Config ID so that all the configurations done using the Config ID are moved to the
Pre-production tenancy.
Closing a Config ID bundles all the
configuration changes that you have made using that Config ID, and the closed Config
ID is available in the queue for Configuration Movement.
Note:
Configurations are moved from Non-production tenancy to Pre-production tenancy in the order in which the corresponding Config IDs are closed.Before trying to
close a Config ID, consider the following conditions:
- Close the Config ID only if it is used to perform any configurations. If you have not done any configurations using a Config ID, you cannot close it. In this case, delete the Config ID instead.
- If any of the configurations done using a Config ID is in In Progress status, you will not be able to close the corresponding Config ID. Once the configuration is promoted from In Progress to Active status, you can close the corresponding Config ID.
- Do not attempt to close the Config ID while it is Active for the current login session. Switch to another Config ID and close it.
To close a Config ID, perform the following procedure:
Once a Config ID is closed, the configuration changes within it are queued up
for movement to Pre-Production tenancy, and the Config ID cannot be further used to save
any configurations.