Set Up the Email Attributes

You may configure the profile switches that relate to sending and receiving email after an extract, transform, and load (ETL) operation has completed, as well as sending email for scheduled reports.

The following is the list of profile switch along with their value required to be set for email messages and delivery.

Table 8-2 Email Specific Attribute-Value set

Attribute	Value
ETL EMAIL SETUP	0 — Send no email message after an ETL operation. 1 — Send an email message only if an initial or incremental ETL fails. 2 — Send an email message only if an initial or incremental ETL succeeds. 3 — Send an email message after any initial or incremental ETL (failure or success).
ETL EMAIL RECEIVER ADDRESS	Specify the email address of each administrator who should receive email status messages of the ETL process. Use a semi-colon to separate each entry. If the Value field blank, then no email messages are sent.
EMAIL SENDER ADDRESS	Specify the email address of each administrator who should receive email status messages of the ETL process. Use a semi-colon to separate each entry. If the Value field blank, then no email messages are sent.
FAILED RECIPIENTS STATUS EMAIL ADDRESS	Specify the email address of the user who will receive information about undeliverable emails.

To configure the attributes related to email messages and delivery:

1. On the Administration Tools screen, click the List Maintenance tab.
2. From the List Maintenance Items group, select Profile Switches.
3. From the Attributes group, select a profile switch, and click Modify.
   The Modify Attributes dialog box appears.

   Note:

   See Table 8-2.
4. In the Value field, enter a value, and click OK.

   The profile switch is set and you return to List Maintenance tab.

Note:

Make sure you validate the network proxy settings before executing the Incremental ETL.

Refer to Oracle Argus Insight Installation Guide, Section 9.1.6 Verify and Update Network Proxy Settings.