Go to main content

Administering the Disaster Recovery Framework for Oracle® Solaris Cluster 4.4

Exit Print View

Updated: June 2019
 
 

How to Modify a Protection Group

Perform this procedure to modify the properties of a protection group.


Note -  You can also accomplish this procedure by using the Oracle Solaris Cluster Manager browser interface. Click Partnerships, click the partnership name to go to its page, click the protection group name to go to its page, click the Properties tab, then click Edit to access the list of editable properties. For Oracle Solaris Cluster Manager log-in instructions, see How to Access Oracle Solaris Cluster Manager in Administering an Oracle Solaris Cluster 4.4 Configuration.

Before You Begin

Ensure that the protection group you want to modify exists locally.

  1. Log in to one of the cluster nodes.

    You must be assigned the Geo Management rights profile to complete this procedure. For more information, see Disaster Recovery Framework Rights Profiles in Installing and Configuring the Disaster Recovery Framework for Oracle Solaris Cluster 4.4.

  2. Modify the configuration of the protection group.

    This command modifies the properties of a protection group on all nodes of the local cluster. If the partner cluster contains a protection group of the same name, this command also propagates the new configuration information to the partner cluster.

    # geopg set-prop -p property-setting [-p...] protection-group
    –p property-setting

    Specifies the properties of the protection group.

    For more information about the protection group properties you can set, see Standard Disaster Recovery Framework Properties.

    protection-group

    Specifies the name of the protection group.

    For information about the names and values that are supported by the disaster recovery framework, see Legal Names and Values of Disaster Recovery Framework Entities.

    For more information about the geopg command, see the geopg(8) man page.