1. Oracle ZFS Storage Appliance Installation Guide, Release OS8.8.x
  2. Installation Prerequisites and Hardware Overviews
  3. Overview of the Sun ZFS Storage 7120 Controller

Overview of the Sun ZFS Storage 7120 Controller

This section provides an overview of the Sun ZFS Storage 7120 controller. For installation instructions, refer to Installing a Sun ZFS Storage 7x20 Controller. For service instructions, refer to the Oracle ZFS Storage Appliance Customer Service Manual, Release OS8.8.x.

Sun ZFS Storage 7120 Physical Specifications

The Sun ZFS Storage 7120 controller 2U chassis dimensions are as follows:

Dimension Measurement Dimension Measurement

Height

87.6 mm/3.45 in

Depth

765.25 mm/30.13 in

Width

436.8 mm/17.2 in

Weight

29.54 kg/65 lb

Refer to https://www.oracle.com/storage/nas/index.html for the most recent component specification.

Sun ZFS Storage 7120 Electrical Specifications

The following list shows the electrical specifications for Sun ZFS Storage 7120. Note that the power dissipation numbers listed are the maximum rated power numbers for the power supply. The numbers are not a rating of the actual power consumption of the appliance.

Connectors

  • Two C13 connectors, which work on 110-220v outlets

Input

  • Nominal frequencies: 50/60Hz

  • Nominal voltage range: 100-120/200-240 VAC

  • Maximum current AC RMS: 13.8A @ 100 VAC

  • AC operating range: 90-264 VAC

Output

  • 3.3 VDC STBY: 3.0A

  • +12 VDC: 86.7A

Power dissipation

  • Max power consumption: 1235.3 W

  • Max heat output: 4212 BTU/hr

  • Volt-Ampere rating: 1261 VA @ 240 VAC, 0.98P.F.

Sun ZFS Storage 7120 Front Panel Components

The following figure and legend show the Sun ZFS Storage 7120 front panel and the drive locations. The Logzilla 3.5" SSD belongs in slot 3 and is not supported in controllers configured with the internal Sun Aura flash HBA Logzilla.


Graphic showing the components on the controller front panel

1 Locator LED/button (white)

2 Service Action Required LED (amber)

3 Power button

4 Power/OK LED (green)

5 HDD 0

6 HDD 1

7 HDD 2

8 HDD or SSD 3

9 HDD 4

10 HDD 5

11 HDD 6

12 HDD 7

13 HDD 8

14 HDD 9

15 HDD 10

16 HDD 11

17 Drive map

     

Sun ZFS Storage 7120 Rear Panel Components

The following figure and legend show the Sun ZFS Storage 7120 rear panel.

Note:

Optional Sun Dual Port 40Gb/sec 4x Infiniband QDR HCAdapter PCIe cards (375-3606-01) may be located in slots 1, 2, or 3. 375-3606-01 HCA expansion cards are not supported in the 10Gb network configurations. For more information about PCIe cards, see Sun ZFS Storage 7120 PCIe Options in Oracle ZFS Storage Appliance Customer Service Manual, Release OS8.8.x.

Graphic showing the components at the back of the controller

1 Power Supply Unit 1

2 Power Supply Unit 0

3 PCIe 0

4 PCIe 3

5 PCIe 1

6 PCIe 4

7 Boot HDD 1

8 Boot HDD 0

9 Rear Panel System Status LEDs

10 Serial Management port

11 Network Management port

12 Gbit Ethernet ports NET 0, 1, 2, 3

13 USB 2.0 ports (0, 1)

14 HD15 Video port

 

The Sun ZFS Storage 7120 controller has the following ports:

  • Ethernet Ports - There are four RJ-45 Gigabit Ethernet ports (NET 0, NET 1, NET 2, NET 3) located on the motherboard that operate at 10/100/1000 Mbit/sec. These network interfaces must be configured before use.

  • Network Management Port - The network management connector (NET MGT) is an RJ-45 port and provides an alternate terminal interface to the SP console.

    Graphic showing the network management port

  • Serial Management Port - The serial management connector (SER MGT) is an RJ-45 port and provides a terminal connection to the SP console.

    Graphic showing the serial management port