1. Preparing to Install the Server
Server Installation Task Checklist
Sun Fire X4470 Server Supported Components and Capabilities
2. Installing the Server Into a Rack With Slide-Rails
Server Installation Process Overview
Installing the Mounting Brackets Onto the Server
Installing the Server Into the Slide-Rail Assemblies
Install Server Into the Slide-Rail Assemblies
Installing the Cable Management Arm
Verifying Operation of the Slide-Rails and CMA
Verify Operation of Slide-Rails and CMA
3. Attaching Cables and Power Cords
Back Panel Connectors and Ports
Attaching Cables to the Server
Connecting Power Cords to the Server
4. Connecting to Oracle ILOM and Applying Main Power to the Server
Log In to Oracle ILOM Using a Serial Connection
Log In to Oracle ILOM Using an Ethernet Connection
Test IPv4 or IPv6 Network Configuration
Applying Main Power to the Server
Apply Main Power to the Server
5. Installing or Configuring the Operating System
Installing an Operating System
Configuring a Preinstalled Operating System
6. Configuring the Preinstalled Solaris 10 Operating System
Configuring Server RAID Drives
Configuring the Preinstalled Solaris 10 Operating System
Solaris 10 Operating System User Information
Using the Solaris Installation Program
Reinstalling the Solaris Operating System
Complete the following procedures to attach the slide-rail assemblies to the rack.
Note - The slide rail assemblies support only racks with 9.5-mm square holes and M6 round holes. All other racks, including those racks with 7.2-mm, M5, or 10-32 mounting holes, are not supported. Refer to your rack documentation for information about the size of its rail holes.
To attach slide-rail assemblies to the rack:
Insert the cage nuts prior to performing Step 2. Refer to the Rail Rackmount Kit Overview and Information card for instructions on inserting these cage nuts. This card is included with the rack kit.
You will hear an audible click when the mounting pins engage the rack.
Note - The slide assembly mounting pins accommodate either 9.5 mm square mounting holes or M6 round mounting holes. No other mounting hole sizes are supported.
Figure 2-3 Installing Slide-Rail Assemblies Onto Rack
Figure 2-4 Slide-Rail Mounting Pins
Figure 2-5 Attaching Slide-Rail Assembly to Rack
Refer to your rack documentation for instructions.
Figure 2-6 Extending the Anti-tip Bar
Caution - If your rack does not have an anti-tip bar, the rack could tip over. |