About This Documentation (PDF and HTML)
Server Module and Components Overview
About the Sun Blade 6000 Modular System Chassis
Powering On and Off the Server Module
Preparation Procedures for Service and Operation
Preparing the Server for Service
How to Prepare the Server Module for Service
Performing ESD and Antistatic Prevention Measures
Using an Antistatic Wrist Strap
How to Setup for ESD prevention
Using the Locate LED to Find the Server Module (Optional)
How to Use the ILOM Web Interface to Turn On and Off the Locate LED
How to Remove the Server Module from the Chassis
How to Remove the Server Module Top Cover
Preparing the Server for Operation
Component Removal and Installation Procedures
Removing and Installing Flash Modules
Removing and Installing the Energy Storage Modules
Removing and Installing the Service Processor Board
Removing and Installing USB Flash Drives
Removing and Installing a CPU and Heatsink Assembly
How to Replace the Motherboard Assembly
Diagnostic and Maintenance Information and Procedures
Diagnosing Server Module Hardware Faults
BIOS Power-On Self-Test (POST) Codes
Server Module Maintenance Procedures and Information
Before You Begin
For ILOM access, refer to the Oracle Integrated Lights Out Manager (ILOM ) 3.0 Supplement for the Sun Blade X6275 M2 Server Module.
The CLI prompt appears:
–>
To turn on the Locate LED, enter the following command:
–> set /CH/LOCATE value=Fast_Blink
To turn off the Locate LED, enter the following command at the CLI prompt:
set /CH/LOCATE value=Off
–> show /CH/LOCATE
The output of the command appears.
The value property shows the status as either Fast Blink or Off.
See Also
How to Use the ILOM Web Interface to Turn On and Off the Locate LED