About This Documentation (PDF and HTML)
Overview of the Sun Blade X6275 M2 Server Module
Server Module Front Panel and Indicators
Installing and Powering On the Server Module
About Your Server Module Shipment
Finding the Serial Number and Accessing Warranty Support Information
How to Install Your Server Module
How to Apply Full Power to a Server Module Node
How to Power Off a Server Module Node
Troubleshooting Server Power States
How to Display the ILOM IP Address Using the Web Interface
How to Log In to the ILOM Web Interface Using an Ethernet Connection
How to Log In to the ILOM CLI Using an Ethernet Connection
How to Log Into ILOM Using a Serial Connection
Configuring an ILOM IP Address
How to Configure a DHCP IP Address
How to Configure a Static IP Address
Accessing the Host Console Through ILOM
How to Connect to the Host's Serial Console Using the ILOM Command-Line Interface
How to Connect to the Host Console Using the ILOM Web Interface
You need to use the chassis CMM ILOM to display the network configuration for the ILOM service processor of each server node, including its IP address. This procedure also verifies that a node's ILOM is working correctly and that you can access it through the CMM ILOM.
Before You Begin
The chassis CMM should already be connected to the network using its Ethernet management port, configured and operational. If not, refer to your chassis documentation before proceeding.
For example, enter the command:
$ ssh username@CMMIPaddress
where username is a user account with administrator privileges and the CMMIPaddress is the IP address of the CMM ILOM.
Tip - The default ILOM administrator account user name is root and the password is changeme. If this default administrator account has been changed, contact your system administrator for an ILOM user account with administrator privileges.
Once you are successfully logged in to the CMM ILOM, you will see the ILOM prompt (->).
-> show /CH/BL0/NODE0/SP/network
where BL0 represents a Sun Blade X6275 M2 server blade slot 0 in the chassis and NODE0 is node 0 of the server. The CMM ILOM displays information about the server module, including its IP address and MAC address.
The following example shows Blade 0, Node 0, server module information:
-> show /CH/BL0/NODE0/SP/network /CH/BL0/NODE0/SP/network Targets: Properties: type = Network Configuration commitpending = (Cannot show property) ipaddress = IPaddress <-- Node SP IP address ipdiscovery = dhcp ipgateway = IPgateway ipnetmask = 255.255.255.0 macaddress = Macaddress pendingipaddress = IPaddress pendingipdiscovery = dhcp pendingipgateway = IPgateway pendingipnetmask = 255.255.255.0 Commands: cd set show ->
You need to know the IP address of the node SP in order to log in directly to the node ILOM. By default, the IP address of the node SP is configured using DHCP, if you want to set a static IP address, see Configuring an ILOM IP Address.
Replace NODE0 with NODE1.
-> exit
Next Steps