JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Sun Server X2-8 (formerly Sun Fire X4800 M2) Service Manual     Sun Server X2-8 (formerly Sun Fire X4800 M2) Documentation Library
search filter icon
search icon

Document Information

Using This Documentation

Sun Server X2-8 Name Change

Product Downloads

Documentation and Feedback

About This Documentation

Change History

Sun Server X2-8 Service Manual Overview

Server and Component Overview

Sun Server X2-8 Overview

Component Overviews

Power and Reset

Power Modes

Power Button and Power OK LED

How to Power On the Server

How to Power Off the Server

Controlling Server Power Remotely

Removing and Installing Components

Preparing for Service and Operation

Removal and Installation Procedures

Removing and Installing a Power Supply (CRU)

Removing and Installing a Hard Drive (CRU)

Removing and Installing a Hard Drive Filler

Replacing the Hard Drive Backplane (FRU)

Adding, Removing, and Installing a CMOD (CRU)

CPU Module (CMOD) Designation and Population Rules

Removing and Installing a CMOD Filler

How to Replace the CMOD Battery (CRU)

Removing and Installing DIMMs (CRU)

DIMM Population Rules

Removing and Installing a RAID Expansion Module (CRU)

Removing and Installing a Fabric Expansion Module (CRU)

How to Remove a Fabric Expansion Module

How to Install a Fabric Expansion Module

Replacing a CPU and Heatsink Assembly (FRU)

Removing and Installing a Fan Module (CRU)

Replacing a Fan Module Controller Board (FRU)

Removing and Installing a NEM or a NEM Filler (CRU)

Removing and Installing a PCIe EM (CRU)

Removing and Installing the Service Processor Module (CRU)

Removing and Installing the Multiport Cable

Removing and Installing the Subassembly Module (FRU)

Sun Server X2-8 Service Procedures and Information

Managing FRUID Information

Firmware Information and Procedures

How to Access the BIOS Setup Utility

BIOS Setup Utility Screens

Component LED Locations and Functions

Thermal Sensor Locations

Sun Server X2-8 Specifications

Physical Specifications

Power Specifications

Environmental Specifications

Requesting Physical Media

How to Request Physical Media Online

How To Request Physical Media by Phone


How to Remove a Fabric Expansion Module

An animation of the procedure to remove a FEM is available. See animation showing FEM removal.

Before You Begin

  1. Prepare the server for service. See How to Prepare for Service.
  2. Remove the CMOD from the server. See How to Remove a CPU Module (CMOD).
  3. Set the CMOD on a flat antistatic surface with ample surrounding space and light.
  4. Remove the CMOD cover. See How to Remove the CPU Module (CMOD) Cover.
  5. To disconnect the FEM from the connector on the motherboard, push down on the FEM release button on the rear of the server.

    This action ejects the FEM from its connector.

    image:An illustration showing the removal of the FEM.
  6. Carefully lift the FEM at the connector end.

    The FEM is secured at the opposite end by a retaining clip on the front support bracket.

  7. To remove the FEM, slide it away from the retaining clip and out of the server.

Next Steps

How to Install a Fabric Expansion Module.

See Also