| Skip Navigation Links | |
| Exit Print View | |
|
Sun Datacenter InfiniBand Switch 648 Topic Set |
Documentation, Support, and Training
Understanding Administrative Commands
Monitoring the InfiniBand Fabric
Controlling the InfiniBand Fabric
Understanding Signal Routing Through the Switch
Understanding Switch Startup and Component Addition
Understanding ILOM on the Switch
Switching Between the ILOM Shell and the Linux Shell
Controlling ILOM Targets (CLI)
Upgrading the Switch Firmware Through ILOM (CLI)
Administering ILOM (Web Interface)
Access ILOM From the Web Interface
Monitoring ILOM Targets (Web Interface)
Controlling ILOM Targets (Web Interface)
Upgrading the Switch Firmware Through ILOM (Web Interface)
Understanding InfiniBand Cabling
Understanding Switch Specifications
Understanding the Installation
Installing the InfiniBand Software Stack
Verifying the InfiniBand Fabric
Understanding Service Procedures
Servicing the Fabric Cards and Fabric Card Fillers
Servicing the InfiniBand Cables
Doing Supportive Software Tasks
Understanding Switch-Specific Commands
Display information about targets, properties and commands.
show [-d targets|properties|commands|all]|[-l 1|2|3...255|all][-o table][target][property property...]
where:
target is the target and path to act upon.
property is the property of the target to show.
This ILOM command displays information about targets, their properties, and associated commands. If no target is specified, information about the current target is displayed.
The following table describes the options to the show command and their purposes:
|
The following example shows how to display the ILOM user accounts with the show command.
-> show -d targets /SP/users
/SP/users
Targets:
root
ilom-admin
ilom-operator
for_Check
test
->
|