2. Fibre Channel Configuration Overview
3. Administering Multipathing Devices Through mpathadm Commands
4. Configuring Multipathing Software
7. Configuring IPFC SAN Devices
8. Solaris 10 10/08 x86/x64 Fibre Channel Operating System Booting Procedure
9. Persistent Binding for Tape Devices
A. Manual Configuration for Fabric-Connected Devices
Fabric Device Node Configuration
Ensuring That LUN Level Information Is Visible
To Ensure LUN Level Information is Visible
To Detect Fabric Devices Visible on a Host
Configuring Device Nodes Without Multipathing Enabled
To Configure an Individual Device Without Multipathing
To Configure Multiple Devices Without Multipathing
Configuring Device Nodes With Solaris Multipathing Software Enabled
To Configure Individual Devices With Sun StorageTek Traffic Manager Software
To Configure Multiple Devices With Multipathing
To Unconfigure a Fabric Device
To Unconfigure All Fabric Devices on a Fabric-Connected Host Port
To Unconfigure One Path to a Multipathing Device
To Unconfigure All Fabric-Connected Devices With Multipathing Enabled
In the Solaris 10 OS, fabric-connected devices are made available to the Solaris host. This differs from previous versions of the Sun StorageTek Traffic Manager software running on the Solaris 8 or the Solaris 9 OS. In those versions, manual configuration steps were required to achieve fabric-connected device availability.
If you want to manually configure the fabric-connected devices, use the following steps to change the default behavior on the Solaris 10 host.
Note - Changing the default behavior makes all of your fabric-connected devices unavailable, which can cause problems for fabric-connected devices that are required to be available at boot time.