2. Fibre Channel Configuration Overview
3. Administering Multipathing Devices Through mpathadm Commands
4. Configuring Multipathing Software
7. Configuring IPFC SAN Devices
8. Solaris 10 10/08 x86/x64 Fibre Channel Operating System Booting Procedure
9. Persistent Binding for Tape Devices
A. Manual Configuration for Fabric-Connected Devices
To Ensure LUN Level Information is Visible
To Detect Fabric Devices Visible on a Host
Configuring Device Nodes Without Multipathing Enabled
To Configure an Individual Device Without Multipathing
To Configure Multiple Devices Without Multipathing
Configuring Device Nodes With Solaris Multipathing Software Enabled
To Configure Individual Devices With Sun StorageTek Traffic Manager Software
To Configure Multiple Devices With Multipathing
To Unconfigure a Fabric Device
To Unconfigure All Fabric Devices on a Fabric-Connected Host Port
To Unconfigure One Path to a Multipathing Device
To Unconfigure All Fabric-Connected Devices With Multipathing Enabled
After you configure the hardware in your direct-attach system or SAN, you must ensure that the hosts recognize the devices. This section explains host recognition of fabric devices, also known as 24-bit FC addressing devices on the SAN. After configuring the devices, ports, and zones in your SAN, make sure that the host is aware of the devices. You can have up to 16 million fabric devices connected together on a SAN with FC support.
This section is limited to the operations required from the perspective of the Solaris 10 OS. It does not cover other aspects, such as device availability and device-specific management. If devices are managed by other software, such as a volume manager, refer to the volume manager product documentation for additional instructions.