Configuring IP Routing

Now you are ready to set up the values that will be used for routing IP.

1. Pull down the Services menu and choose IP => IP Interface. The IP Interface Configuration window appears.

2. Enter the information about the IP network that this router will attach to.

   Click on the Add button. The snapshot below summarizes the changes you need to make for this example configuration:

   Figure 8-7 Configuring the IP Routing

   
   

   You always need to specify the local IP address. You should also specify the IP subnet mask. To use the network default, leave the subnet mask field blank.

   Once you have made the changes, click on Apply. In most instances, the default settings are sufficient, but if you need to change the default X.25 parameters, click on Modify, then click on the X.25 Parameters button to access the X.25 Configuration for IP Interface window.

   The snapshot below summarizes the changes you need to make for this example configuration:

   Figure 8-8 Configuring the X.25 Parameters for the IP Interface

   
   

   Unless you are connecting to the Defense Data Network (DDN), specify CCITT address mapping.

   To restrict access and so add a measure of security, you can choose not to accept calls from unknown hosts. A host is unknown if its address is not included in the Remote Host to X.25 Address Map. Refer to "IP Interface Configuration".

   The Listen Information is useful if the machine you are configuring has more than one address. You can use it to restrict which address(es) will respond.

   You can also filter incoming calls based on their Call User Data. Take care not to delete the initial CC if you are using this parameter--this specifies that calls are for IP. Without the initial CC, calls will fail. Refer to "IP Interface Configuration" for more detail.

3. Configure information mapping remote IP addresses to remote X.25 addresses.

   Pull down the Services menu and choose IP => IP Mapping. The Remote IP Host to X.25 Address Map window appears. The snapshot below summarizes the information you need to add. Again, you can keep most of the default values:

   Figure 8-9 Information Mapping of Remote IP Addresses to Remote X.25 Address.

   
   

   You can enter a host name which has been defined in /etc/hosts in place of the remote IP address.

4. Click on OK to save the changes and to dismiss the window.

5. Start X.25 by pulling down the Network menu and clicking on Start X.25.

   To check that the configuration works, try to ping the remote machine or to rlogin.