Use a short Phillips screwdriver to complete this procedure.
Remove the panels covering the LED board.
Complete the steps in "Removing the Front and Side Panels".
Disconnect the key switch lock and PWB centerplane cables from the LED board. See Figure E-9.
Remove the four screws securing the LED board to the chassis.
There is one screw in each corner of the LED board.
Remove the LED board.
Orient the LED board so that the three LEDs are visible through the chassis window cutout.
Insert a screw into the front right corner of the LED board.
Use this screw as a guide and place the LED board against the chassis.
Slightly tighten the first screw and attach this corner of the LED board to the chassis.
Replace the three other screws that attach the LED board to the chassis.
Tighten all four screws.
Connect the key switch lock and PWB centerplane cables to the LED board. See Figure E-9.
The key switch lock and PWB centerplane cables are keyed so that the cables fit into the connectors in only one direction and cannot be reversed.
Replace the panels covering the LED board.
Complete the steps in "Replacing the Front and Side Panels".