| Exit Print View | |
Sun Datacenter InfiniBand Switch 648 Topic Set |
|
Documentation, Support, and Training
Understanding ILOM on the Switch
Switching Between the ILOM Shell and the Linux Shell
Switch From the ILOM Shell to the Linux Shell
Switch From the Linux Shell to the ILOM Shell
Display the Date, Time, and Time Zone (CLI)
Display the Aggregate Sensor State (CLI)
Display the ILOM Sessions (CLI)
Display the ILOM Event Log (CLI)
Checking the Status of Services (CLI)
Display the HTTP Service Status (CLI)
Display the HTTPS Service Status (CLI)
Display the SSL Certificates (CLI)
Display the SNMP Service Status (CLI)
Display the SNMP Service User Accounts (CLI)
Display the SNMP Service Communities (CLI)
Display the IPMI Service Status (CLI)
Get Help on an ILOM Command (CLI)
Get Help on an ILOM Target Property (CLI)
Display the Alert Properties (CLI)
Display the ILOM User Accounts (CLI)
Display the Remote Log Hosts (CLI)
Display the Network Management Configuration (CLI)
Display the ILOM CLI Session Timeout (CLI)
Display Chassis FRU ID Information (CLI)
Display the ILOM Firmware Version (CLI)
Controlling ILOM Targets (CLI)
Performing General Tasks on ILOM Targets (CLI)
Set the Date, Time, and Time Zone (CLI)
Clear the ILOM Event Log (CLI)
Set the Remote Log Hosts (CLI)
Back Up the ILOM Configuration (CLI)
Restore the ILOM Configuration (CLI)
Set the Network Management Parameters (CLI)
Performing ILOM User Tasks (CLI)
Add an ILOM User Account (CLI)
Change an ILOM User's Password and or Role (CLI)
Delete an ILOM User Account (CLI)
Disable the HTTP Service (CLI)
Enable the HTTPS Service (CLI)
Install a Custom SSL Certificate (CLI)
Remove the Custom SSL Certificate (CLI)
Disable the HTTPS Service (CLI)
Configure the SNMP Service (CLI)
Add SNMP Service User Accounts (CLI)
Modify SNMP Service User Accounts (CLI)
Delete SNMP Service User Accounts (CLI)
Add SNMP Service Communities (CLI)
Modify SNMP Service Communities (CLI)
Delete SNMP Service Communities (CLI)
Back Up SNMP Service MIBs (CLI)
Disable the SNMP Service (CLI)
Enable Alerts to Send SNMP Traps (CLI)
Enable Alerts to Send PET (CLI)
Set the ILOM CLI Session Timeout (CLI)
Upgrading the Switch Firmware Through ILOM (CLI)
Install the flint Application (CLI)
Download the Switch Firmware Package (CLI)
Set Component Firmware to Upgrade (CLI)
Upgrade the Switch Firmware (CLI)
The H8 is installed on every line card, fabric card, and fabric card filler as an interface between the IPMB bus and the component’s hardware. The H8 chips have firmware that enables them to translate commands from the CMC to appropriate control signals, and interpret data from sensors into coherent values the CMC can understand.
The switch chips have firmware that instructs how to route links, set data rates, and configure signal parameters.
When you install a new line card, fabric card or fabric card filler, the H8 firmware and switch chip firmware might not be the same as for the other components. Additionally, a newer version of the firmware might become available.
|
