Documentation, Support, and Training
Check Network Management Port Status LEDs
Check Power Supply Status LEDs
Understanding Routing Through the Switch
CXP Connectors and Link LEDs to Switch Chip Port Routes
Switch Chip Port to Switch Chip Port Routes
Switch Chip Port to CXP Connectors and Link LED Routes
Signal Route Through the Switch
Administrative Command Overview
Display Switch Environmental and Operational Data
Display Switch Firmware Versions
Display Switch Chip Boot Status
Display Switch Chip Port Status
Monitoring the InfiniBand Fabric
Identify All Switches in the Fabric
Identify All HCAs in the Fabric
Display the InfiniBand Fabric Topology
Display a Route Through the Fabric
Display the Link Status of a Node
Display Data Counters for a Node
Display Low-Level Detailed Information About a Node
Display Low-Level Detailed Information About a Port
Restart the Management Controller
Recover Ports After Switch Chip Reset
Change the Administrator Password
Controlling the InfiniBand Fabric
Perform Comprehensive Diagnostics for the Entire Fabric
Perform Comprehensive Diagnostics for a Route
Determine Changes to the InfiniBand Fabric Topology
Find 1x or SDR or DDR Links in the Fabric
Determine Which Links Are Experiencing Significant Errors
Controlling the Subnet Manager
Set the Subnet Manager Priority
Start the Subnet Manager With the opensmd Daemon
The output of some InfiniBand commands identify a node by its GUID. You can determine the switch chip or InfiniBand cable connection associated with that GUID using this procedure.
In the output of the InfiniBand command, identify the GUID and port in question.
For example, given the following output from the ibdiagnet command:
-W- lid=0x0055 guid=0x0021283a8638b0c0 dev=48438 Port=21
In this example, the GUID is 0x0021283a8638b0c0 and the port is 21.
Truncate all digits of the GUID except the four digits on the right.
For example, GUID 0x0021283a8638b0c0 is truncated to b0c0.
The b0 means that the node is inside of a Sun Datacenter InfiniBand Switch 72. The c means that the node is located in I4 switch chip C. The port is 21.
Use the tables in Understanding Routing Through the Switch to cross-reference the routing to other switch chips and ports and to connections.
For example, using Switch Chip Port to CXP Connectors and Link LED Routes, I4 switch chip C, port 21 routes to connector 6A, the center LED, and the link is carried by P2.