Flash Module Architecture Overview
Energy Storage Module Overview
Perform ESD Prevention Measures
Install the Card Into a System
FMod Alignment for Optimal Performance
(Optional) Using the SAS/SATA Controller as a Boot Device
SAS/SATA Controller as a Boot Device
Configure the SAS/SATA Controller as a Boot Device (SPARC Systems)
Configure the SAS/SATA Controller as a Boot Device (x86 Systems)
Replacing FMod Retention Clips
Update the FMod Firmware (Oracle Solaris OS)
Update the FMod Firmware (Windows and Linux OS)
Updating the SAS/SATA Controller Firmware
Update the SAS/SATA Controller Firmware (Oracle Solaris OS)
Update the SAS/SATA Controller Firmware (Linux OS)
Some systems accept only full-height PCIe cards. These instructions describe how to install the full-height PCIe bracket onto the card.
Note - Note the FMod locations. Each FMod must be installed in the same slot from which it was removed.
See Remove an FMod.
Remove the two Phillips No. 1 screws that secure the bracket to the card.
Secure the bracket with two Phillips No. 1 screws.
Note - Note the FMod locations. Each FMod must be installed in the same slot from which it was removed.
See Install an FMod.