U-Boot Normal Mode– Test Output Sample

Example 1 is a sample output of a U-Boot test after it ran in -Normal mode.

Example 1 U-Boot Normal Mode– Test Output

U-Boot 1.1.4

Custom AST2100 U-Boot 2.0 (Jan 26 2009 - 10:29:26) r41480

DRAM:  119 MB
Flash bank 0 at 10000000 has 0x2000000 bytes in 256 sectors (chipSize 1<<25, size_ratio
1).
Flash: 32 MB

readonly: ethaddr=00:14:4F:CA:B5:10

readonly: eth1addr=00:14:4F:CA:B5:11
VUART1 already enabled at port 0x03f8, SerIRQ[4] rise
Protecting U-Boot flash sectors; monitor_base=100a0000.
Negating BIOS_TOP_BLOCK_LOCK signal.

H/W: <product_name> Service Processor; SOC: AST2100 Rev. 02 (’A3’)
PWC_SP_Broken_OD = 0;  ARM restart caused by: watch-dog ExtRst# pin
The host is OFF(S5) (hostWantsPwr=0, powerGood=0,
allowPwrOn=0|0, outOfReset=0, fatalError=0).
Reset straps=0x88819180, def. H-PLL=264 MHz, CPU/AHB=2:1, boot CS0# normal speed
PCI w/VGA noVBIOS;  DRAM clock is M-PLL: 264 MHz (DDR2-528)
DRAM: 128MB data - 8MB VGA, 32-bit noECC, 2 BA 10 CA, CL=4 BL=4 ap=1, 61440 us refr
Board Revision - cc
Net:   faradaynic#0, faradaynic#1

Enter Diagnostics Mode [’q’uick/’n’ormal(default)/e’x’tended(manufacturing mode)] .....0
Diagnostics Mode - NORMAL
<DIAGS> Memory Data Bus Test ... PASSED
<DIAGS> Memory Address Bus Test ... PASSED
I2C Probe Test - Motherboard
Bus Device                  Address Results
============================================
1 Temp.Sensor (VM75)(U3006) 0x90 PASSED
2 Sys FRUID   (U3003)       0xA0 PASSED
2 Power CPLD  (U3301)       0x4E PASSED
2 CPU0 Fault LED’s (U3001)  0x40 PASSED
2 CPU1 Fault LED’s (U3002)  0x42 PASSED
2 PCA9555 (Misc) (U3005)    0x44 PASSED
2 DIMM IMAX (U3102)         0x12 PASSED
6 Bank Panel Led’s (U2701)  0xC6 PASSED
6 DS1338(RTC)( U803)        0xD0 PASSED

I2C Probe Test - Chassis (2U)
PDB Board:
Bus Device              Address Results
============================================
1   PCA9548 Mux (U0202) 0xE0    PASSED
1   PDB FRUID (U0203)   0xAA    PASSED
1   MAX7313 (U0201)     0x40 PASSED

Power Supply 0
Bus Device           Address   Results
============================================
1 0 PS 0 FRUID ( - ) 0xAC     PASSED
1 0 PS 0 CTRL (-)    0x7C     PASSED

Power Supply 1
Bus  Device         Address Results
============================================
1 1  PS 1 FRUID (-) 0xAC    PASSED
1 1  PS 1 CTRL ( - )0x7C    PASSED

Fan Module  1
Bus  Device                Address  Results
============================================
1 2   FM 1 FRUID   (U0203) 0xAC     PASSED
1 2   FM 1 PCA9555 (U0201) 0x42     PASSED
1 2   FM 1 ADT7462 (U0202) 0xB8     PASSED

Fan Module  0
Bus  Device               Address   Results
============================================
1 3  FM 0 FRUID   (U0203) 0xAC     PASSED
1 3  FM 0 PCA9555 (U0201) 0x42     PASSED
1 3  FM 0 ADT7462 (U0202) 0xB8     PASSED

6 Disk Backplane
Bus  Device             Address  Results
============================================
1 4  BP MAX7313 (U1801) 0x44     PASSED
1 4  BP FRUID (U2102)   0xAC     PASSED

Paddle Card
Bus     Device            Address  Results
============================================
1 4     EXP FRUID (U0401) 0xAE     PASSED
<DIAGS> PHY #0 R/W Test ...        PASSED
<DIAGS> PHY #0 Link Status ...     PASSED
<DIAGS> ETHERNET PHY #0, Internal Loopback Test ... PASSED
<DIAGS> USB 1.1 Test ...           PASSED
<DIAGS>Access to BIOS Flash ...    PASSED
<DIAGS> Testing PowerCPLD version ...PASSED
Booting linux in 3 seconds...