How to Remove the Server from the Rack

---

Caution - Potential for physical harm to personnel or component and facility damage. The weight of the server and uneven weight distribution within the rack can cause physical harm to personnel and damage to components and the facility. Always use a mechanical lift or more than one person to remove the server from the rack. Always use your rack anti-tip bar, keep the weight distribution to the lower end of the rack, and do not extend more than one server at a time.

---

Use this procedure to safely remove the server from the rack for service or maintenance purposes.

1. Power off the server.
2. Disconnect all cables from the rear of the server.

   If necessary, label the cables first.

3. Extend the anti-tip bar at the bottom of the server.

   The anti-tip bar prevents the rack from tipping over and causing physical harm to personnel and damage to components and the facility.

4. Squeeze and hold the green slide-rail lock tabs that are located on both sides of the front of the server.
5. Pull the server away from the rack until both slide rails lock with an audible click.

   ---

   Caution - Include additional personnel from this step forward.

   ---

6. Locate the slide lock release tabs.

   The release tabs are located on both sides of the server near the center of the mounting brackets.

7. Prepare to remove the server from the rack. Position at least one person on each side of the rack holding the server.
8. Pull the slide lock release tabs forward and then pull the server slightly away from the rack just far enough to disengage the slide locks.

   This action releases the server from the rack allowing it to slide freely.

   ---

   Caution - Do not leave the server unattended.

   ---

9. Slide the server away from the rack until the mounting brackets on the side of the server clear the rails.
10. Set the server on a flat stable surface.
11. If necessary, push the extended rails into the rack.