Fixed and Open Issues

C H A P T E R 1

This chapter contains a table of the fixed and open issues for the Sun Blade 6048 modular system. Each issue contains a link to a further description of the issue.

An issue with an Open status means that there is not an available fix for the bug yet. If a workaround is available, it is explained in the bug description.

The ILOM issues are grouped according to whether they are opened or fixed in a specific ILOM version (chassis software version is also shown in parenthesis).

TABLE 1 Sun Blade 6048 Modular System Issues
Issue	Status	Workaround Available?
Hardware Open Issues
Important Caution for Chassis Midplane Replacement	Open	No
NEM LEDs (6713414)	Open	Yes
Power Supply Connections (6615994) (6576346)	Open	Yes
Power Supply Watt Meter Feature Not Available for A231 Power Supplies (6614183)	Open	Yes
Power Consumption Is Invalid in ILOM if PSU Side Is Under 25A (6438921)	Open	Yes
ILOM Open Issues
ILOM 3.0.6.11 Requires Both Power Supplies to Be Powered Up (6874117)	Open	Yes
ILOM 3.0.3.32 Displays Power Assert/Deassert Errors in Event Log (6865366)	Open	No
Reset Server Modules Running ILOM 2.0.3.10 After Updating the CMM to ILOM 3.0.3.32 (6813351)	Open	Yes
Moving the CMM to a Different Chassis Can Cause Incorrect Product Data (6821052)	Open	Yes
Cannot Set Netmask When Running ILOM 2.0.3.10 (6766379)	Open	Yes
Locate LED Does Not Turn on During Chassis Lamp Test (6713569, 6711416)	Open	Yes
The stop /CH Command in ILOM 2.0.3.2 is Different Than in ILOM 2.0.3.1 (6679679)	Open	No
/CH/LOCATE Does Not Turn Off When Set to ON Using the ILOM CLI or ipmitool (6695802)	Open	No
SP Login Through Web GUI Fails After a New IP Address Is Assigned (6745118)	Open	Yes
SP Reports Incorrect FM, NEM, and Server Module Removal and Insertion Events (6744044)	Open	No
The Tempfail LED and Service LED On the Rear of the Chassis Functionality Is Switched (6745875)	Open	No
Fixed in ILOM 3.0.10 (Sun Blade Chassis SW 3.2)
Blade Fan Control Improvement (6903302)	Fixed	No
CMM permitted_power Error Message is Unclear (6863970)	Fixed	No
start /CH or start /CH/NEMx Does Not Warn That Target Is Already Started (6867739)	Fixed	No
Cold Boot of CMM Causes Abnormal Chassis Fan Speed (6876374)	Fixed
NEM OK LED Should Have Blinking State (6864854)	Fixed	No
Fixed in ILOM 3.0.6.11c (Sun Blade 6000 Chassis SW 3.1.3)
CMM Power/OK LED No Longer Works With ILOM 3.0.3.32 (6869525)	Fixed	No
Low Fan Speed With Certain Blade Servers (6911651)	Fixed	No
Fixed in ILOM 3.0.6.11b (Sun Blade 6000 Chassis SW 3.1.2)
ILOM 3.0.3.32 Displays Incorrect Power Failures in Event Log With Certain PSU Firmware (6865366)	Fixed	No
Fixed in ILOM 3.0.6.11 (Sun Blade 6000 Chassis SW 3.1)
Chassis Amber LED Turns on When PSU0 Is Plugged Into the Chassis (6866727)	Fixed	No
CMM Web Interface Slow Response (6853788)	Fixed	No
PSU Fan Speed Should Run Slower (6853866)	Fixed	No
Need to Include Assembly Number for the CMM (6866148)	Fixed	No
Fixed in ILOM 3.0.3.32 (Sun Blade 6000 Chassis SW 3.0)
CMM OK LED Turns Off During Boot (6474460)	Fixed	No
ILOM CMM SP Does Not Display Current Status Information (6516108)	Fixed	No
/CH/LOCATE Does Not Turn Off When Set to ON Using the ILOM CLI or ipmitool (6695802)	Fixed	No
Locate LED Does not Turn on During Chassis Lamp Test (6713569, 6711416)	Fixed	No
SP Reports Incorrect FM, NEM, and Server Module Removal and Insertion Events (6744044)	Fixed	No
SP Login Through Web Interface Fails After a New IP Address Is Assigned (6745118)	Fixed	Yes
Cannot Set Netmask When Running ILOM 2.0.3.10 (6766379)	Fixed	No
Stop, Start and Reset Commands are Disabled for the Virtualized NEM in the Sun Blade 6000 CMM (6813859 and 6812683)	Fixed	No
Fixed in ILOM 2.0.3.10 (Sun Blade 6000 Chassis SW 2.1)
Power LED Does Not Display Until SP Boots (6464862)	Fixed	No
Fixed in ILOM 2.0.3.3 (Sun Blade 6000 Chassis SW 2.0)
The stop /CH Command Lights the Chassis Alert LED (6678328)	Fixed	No
SNMP Trap Destination Port Should Be Configurable (6654887)	Fixed	No
Documentation Open Issue
Service Processor Information Missing From Installation Guide (6692166)	Fixed	No