This appendix shows the Graphics Tower printed circuit board interconnects: test points, connectors, and jumpers, and the power supply wiring diagram.
Figure A-1 GT SBus Adapter Board Interconnects
The GT SBus Adapter Board has no jumpers or interconnects.
Figure A-2 Frame Buffer Board Interconnects
Table A-1 Light Pen Connector
Table A-2 Aux Video (5W5) Connector
Not currently used.
Table A-3 Monitor (13W3) Connector
Figure A-3 Graphics Processor Front End Board Interconnects
Table A-4 Diagnostic Switch
Table A-5 Graphics Processor Front End Board Jumpers
Figure A-4 Graphics Processor Rendering Pipeline Board
Table A-6 Graphics Processor Rendering Pipeline Board - J1401 Jumpers
Table A-7 Graphics Processor Rendering Pipeline Board - J1701 Jumpers
Note - Jumpers J1401 and J1701 provide emulation control for factory test of the TMS320 digital signal processors, U1401 and U1701 respectively. These jumpers are always left out for normal board operation.
Figure A-5 Backplane Layout as Seen From the Bezel Side
The jumpers shown in Figure A-5 (P100 through P300) are not used when this backplane is used in the Graphics Tower.
Figure A-6 Power Supply Connections