How to Remove a PCIe EM

An animation of the procedure to remove a PCIe EM is available. See animation showing PCIe EM removal.

Before You Begin

• PCIe ExpressModule Overview

• PCIe EM Designations, Slot Numbering, and Population Rules

• For hot-plug preparation procedures on an Oracle Solaris 10 OS system, see Prepare a PCIe EM for Hot Plug in Oracle Solaris 10 and Solaris 11

1. If necessary, prepare the server for service. See How to Prepare for Service.
2. Access the back of the server.
3. For hot-plug removal, press the ATTN button on the PCIe EM.

   The LED blinks for approximately five seconds and then turns off indicating that the component is ready for removal.

   For button location, see Back Panel PCIe EM LEDs.

4. Disconnect cables from the PCIe EM.
5. To unlock the PCIe EM, pull out on the underside of the release handle and rotate the handle to the left to its fully open position (1).
   
6. To remove the PCIe EM, use the handle to pull the PCIe EM from its slot (2).
7. If you are replacing a PCIe EM, see How to Install a PCIe EM or PCIe EM Filler.

Next Steps

How to Install a PCIe EM or PCIe EM Filler

See Also

Sun Server X2-8 Subassembly Module Overview