|Skip Navigation Links|
|Exit Print View|
|man pages section 3: Extended Library Functions, Volume 3 Oracle Solaris 11 Information Library|
- process and LWP control in libthread_db
#include <proc_service.h> ps_err_e ps_pstop(struct ps_prochandle *ph);
ps_err_e ps_pcontinue(struct ps_prochandle *ph);
ps_err_e ps_lstop(struct ps_prochandle *ph, lwpid_t lwpid);
ps_err_e ps_lcontinue(struct ps_prochandle *ph, lwpid_t lwpid);
ps_err_e ps_lrolltoaddr(struct ps_prochandle *ph, lwpid_t lwpid, psaddr_t go_addr, psaddr_t stop_addr);
ps_err_e ps_kill(struct ps_prochandle *ph, int signum);
The ps_pstop() function stops the target process identified by ph, while the ps_pcontinue() function allows it to resume.
The libthread_db() function uses ps_pstop() to freeze the target process while it is under inspection. Within the scope of any single call from outside libthread_db to a libthread_db routine, libthread_db will call ps_pstop(), at most once. If it does, it will call ps_pcontinue() within the scope of the same routine.
The controlling process may already have stopped the target process when it calls libthread_db. In that case, it is not obligated to resume the target process when libthread_db calls ps_pcontinue(). In other words, ps_pstop() is mandatory, while ps_pcontinue() is advisory. After ps_pstop(), the target process must be stopped; after ps_pcontinue(), the target process may be running.
The ps_lstop() and ps_lcontinue() functions stop and resume a single lightweight process (LWP) within the target process ph.
The ps_lrolltoaddr() function is used to roll an LWP forward out of a critical section when the process is stopped. It is also used to run the libthread_db agent thread on behalf of libthread. The ps_lrolltoaddr() function is always called with the target process stopped, that is, there has been a preceding call to ps_pstop(). The specified LWP must be continued at the address go_addr, or at its current address if go_addr is NULL. It should then be stopped when its execution reaches stop_addr. This routine does not return until the LWP has stopped at stop_addr.
The ps_kill() function directs the signal signum to the target process for which the handle is ph. It has the same semantics as kill(2).
The call completed successfully. In the case of ps_pstop(), the target process is stopped.
For ps_lstop(), ps_lcontinue() and ps_lrolltoaddr(); there is no LWP with id lwipd in the target process.
The function did not return successfully.
See attributes(5) for description of the following attributes: